KYOCERA 266ci Manual do Utilizador descarregar pdf (Página 145)

HP LaserJet Emulation (Mode 6)

7-33

HP LaserJet Emulation (Mode 6)

On shipment from the factory, the printing system is set to power up in the HP LaserJet

(PCL 6) emulation.

The factory default symbol set is PC-8. To change this default symbol set, use the FRPO

command with the U6 and U7 parameters. The default font is Courier.

To set the printing system to power up in LaserJet mode, send the following PRE-

SCRIBE command:

!R! FRPO P1, 6; FRPO P3, 1; EXIT;

To use the TimesNewRoman font of 14.25 points as the default font, add the following

lines:

FRPO V3, ’TimesNewRoman’;

FRPO V1, 14;

FRPO V2, 25;

See Chapter 6 for details of the FRPO V parameters.

The symbol set can be changed after power-up with the CSET or INTL command, or

from the operator panel keys, or with LaserJet symbol sets typically accessed through

software.

The printing system also supports as many HP symbol sets as the LaserJet regularly sup-

ports and still other symbol sets can be provided in downloaded fonts. (A full list of the

supported symbol sets appear in section LaserJet Symbol Sets on page 37.) These symbol

sets can be used by appropriate font selection commands as explained below.

Fonts can be selected with PRESCRIBE commands, or through the printer driver pro-

vided with your software. The following font sample was created through driver support.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 259 260

Sem comentários

KYOCERA 266ci Manual do Utilizador Página 145