KYOCERA FS-C2026MFP+ Manual do Utilizador descarregar pdf (Página 210)

Chapter 7 Emulation

7-98

Plot Coordinates (bit 0)

This bit defines one of two plotting coordinate modes. (See Figure 7. 29. on page 98.)

0 = Mode A

1 = Mode B

In mode A, the origin (0, 0) starts at bottom left. In mode B, the origin starts at the center

of the page.

Response to SP Instruction (bit 1)

This bit defines the printing system response to the SP (Select Pen) instruction.

0 = Printing System feeds out a page when it receives a SP; or SP 0; instruction.

1 = Printing System returns the pen to the stall from which it came, in other words, it

prints nothing when it receives a SP; or SP 0; instruction.

Figure 7. 29. Plot Coordinates

Automatic Plot Coordinate Mode (bit 2)

0 = Printing System changes the plot coordinate from mode A to mode B when it

receives a IP (Input P1 and P2) instruction using the negative parameter value.

When the IN

(INitialize) instruction is later given, the printing system reverts to mode A.

4 0 0 Landscape page orientation

16 1 Page orientation to FRPO C1

5 0 0 Default cursor at top left

32 1 Default cursor at bottom left

Table 7.28. FRPO G0 Command Options

Bit Position Bit Value Logic Value Description

Mode A (G0, 0;)

Mode B (G0, 1;)

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 259 260

Sem comentários

KYOCERA FS-C2026MFP+ Manual do Utilizador Página 210